v86 0.4.0 → 0.5.11

package/bios/seabios/src/hw/ahci.h

@@ -1,201 +0,0 @@
-#ifndef __AHCI_H
-#define __AHCI_H
-
-#include "block.h" // struct drive_s
-#include "types.h" // u32
-
-struct sata_cmd_fis {
-    u8 reg;
-    u8 pmp_type;
-    u8 command;
-    u8 feature;
-
-    u8 lba_low;
-    u8 lba_mid;
-    u8 lba_high;
-    u8 device;
-
-    u8 lba_low2;
-    u8 lba_mid2;
-    u8 lba_high2;
-    u8 feature2;
-
-    u8 sector_count;
-    u8 sector_count2;
-    u8 res_1;
-    u8 control;
-
-    u8 res_2[64 - 16];
-};
-
-struct ahci_ctrl_s {
-    struct pci_device *pci_tmp;
-    u8  irq;
-    void *iobase;
-    u32 caps;
-    u32 ports;
-};
-
-struct ahci_cmd_s {
-    struct sata_cmd_fis fis;
-    u8 atapi[0x20];
-    u8 res[0x20];
-    struct {
-        u32 base;
-        u32 baseu;
-        u32 res;
-        u32 flags;
-    } prdt[];
-};
-
-/* command list */
-struct ahci_list_s {
-    u32 flags;
-    u32 bytes;
-    u32 base;
-    u32 baseu;
-    u32 res[4];
-};
-
-struct ahci_fis_s {
-    u8 dsfis[0x1c];  /* dma setup */
-    u8 res_1[0x04];
-    u8 psfis[0x14];  /* pio setup */
-    u8 res_2[0x0c];
-    u8 rfis[0x14];   /* d2h register */
-    u8 res_3[0x04];
-    u8 sdbfis[0x08]; /* set device bits */
-    u8 ufis[0x40];   /* unknown */
-    u8 res_4[0x60];
-};
-
-struct ahci_port_s {
-    struct drive_s     drive;
-    struct ahci_ctrl_s *ctrl;
-    struct ahci_list_s *list;
-    struct ahci_fis_s  *fis;
-    struct ahci_cmd_s  *cmd;
-    u32                pnr;
-    u32                atapi;
-    char               *desc;
-    int                prio;
-};
-
-void ahci_setup(void);
-int ahci_process_op(struct disk_op_s *op);
-int ahci_atapi_process_op(struct disk_op_s *op);
-
-#define AHCI_IRQ_ON_SG            (1 << 31)
-#define AHCI_CMD_ATAPI            (1 << 5)
-#define AHCI_CMD_WRITE            (1 << 6)
-#define AHCI_CMD_PREFETCH         (1 << 7)
-#define AHCI_CMD_RESET            (1 << 8)
-#define AHCI_CMD_CLR_BUSY         (1 << 10)
-
-#define RX_FIS_D2H_REG            0x40 /* offset of D2H Register FIS data */
-#define RX_FIS_SDB                0x58 /* offset of SDB FIS data */
-#define RX_FIS_UNK                0x60 /* offset of Unknown FIS data */
-
-/* global controller registers */
-#define HOST_CAP                  0x00 /* host capabilities */
-#define HOST_CTL                  0x04 /* global host control */
-#define HOST_IRQ_STAT             0x08 /* interrupt status */
-#define HOST_PORTS_IMPL           0x0c /* bitmap of implemented ports */
-#define HOST_VERSION              0x10 /* AHCI spec. version compliancy */
-
-/* HOST_CTL bits */
-#define HOST_CTL_RESET            (1 << 0)  /* reset controller; self-clear */
-#define HOST_CTL_IRQ_EN           (1 << 1)  /* global IRQ enable */
-#define HOST_CTL_AHCI_EN          (1 << 31) /* AHCI enabled */
-
-/* HOST_CAP bits */
-#define HOST_CAP_SSC              (1 << 14) /* Slumber capable */
-#define HOST_CAP_AHCI             (1 << 18) /* AHCI only */
-#define HOST_CAP_CLO              (1 << 24) /* Command List Override support */
-#define HOST_CAP_SSS              (1 << 27) /* Staggered Spin-up */
-#define HOST_CAP_NCQ              (1 << 30) /* Native Command Queueing */
-#define HOST_CAP_64               (1 << 31) /* PCI DAC (64-bit DMA) support */
-
-/* registers for each SATA port */
-#define PORT_LST_ADDR             0x00 /* command list DMA addr */
-#define PORT_LST_ADDR_HI          0x04 /* command list DMA addr hi */
-#define PORT_FIS_ADDR             0x08 /* FIS rx buf addr */
-#define PORT_FIS_ADDR_HI          0x0c /* FIS rx buf addr hi */
-#define PORT_IRQ_STAT             0x10 /* interrupt status */
-#define PORT_IRQ_MASK             0x14 /* interrupt enable/disable mask */
-#define PORT_CMD                  0x18 /* port command */
-#define PORT_TFDATA               0x20 /* taskfile data */
-#define PORT_SIG                  0x24 /* device TF signature */
-#define PORT_SCR_STAT             0x28 /* SATA phy register: SStatus */
-#define PORT_SCR_CTL              0x2c /* SATA phy register: SControl */
-#define PORT_SCR_ERR              0x30 /* SATA phy register: SError */
-#define PORT_SCR_ACT              0x34 /* SATA phy register: SActive */
-#define PORT_CMD_ISSUE            0x38 /* command issue */
-#define PORT_RESERVED             0x3c /* reserved */
-
-/* PORT_IRQ_{STAT,MASK} bits */
-#define PORT_IRQ_COLD_PRES        (1 << 31) /* cold presence detect */
-#define PORT_IRQ_TF_ERR           (1 << 30) /* task file error */
-#define PORT_IRQ_HBUS_ERR         (1 << 29) /* host bus fatal error */
-#define PORT_IRQ_HBUS_DATA_ERR    (1 << 28) /* host bus data error */
-#define PORT_IRQ_IF_ERR           (1 << 27) /* interface fatal error */
-#define PORT_IRQ_IF_NONFATAL      (1 << 26) /* interface non-fatal error */
-#define PORT_IRQ_OVERFLOW         (1 << 24) /* xfer exhausted available S/G */
-#define PORT_IRQ_BAD_PMP          (1 << 23) /* incorrect port multiplier */
-
-#define PORT_IRQ_PHYRDY           (1 << 22) /* PhyRdy changed */
-#define PORT_IRQ_DEV_ILCK         (1 << 7) /* device interlock */
-#define PORT_IRQ_CONNECT          (1 << 6) /* port connect change status */
-#define PORT_IRQ_SG_DONE          (1 << 5) /* descriptor processed */
-#define PORT_IRQ_UNK_FIS          (1 << 4) /* unknown FIS rx'd */
-#define PORT_IRQ_SDB_FIS          (1 << 3) /* Set Device Bits FIS rx'd */
-#define PORT_IRQ_DMAS_FIS         (1 << 2) /* DMA Setup FIS rx'd */
-#define PORT_IRQ_PIOS_FIS         (1 << 1) /* PIO Setup FIS rx'd */
-#define PORT_IRQ_D2H_REG_FIS      (1 << 0) /* D2H Register FIS rx'd */
-
-#define PORT_IRQ_FREEZE           (PORT_IRQ_HBUS_ERR | PORT_IRQ_IF_ERR |   \
-                                   PORT_IRQ_CONNECT | PORT_IRQ_PHYRDY |    \
-                                   PORT_IRQ_UNK_FIS)
-#define PORT_IRQ_ERROR            (PORT_IRQ_FREEZE | PORT_IRQ_TF_ERR |     \
-                                   PORT_IRQ_HBUS_DATA_ERR)
-#define DEF_PORT_IRQ              (PORT_IRQ_ERROR | PORT_IRQ_SG_DONE |     \
-                                   PORT_IRQ_SDB_FIS | PORT_IRQ_DMAS_FIS |  \
-                                   PORT_IRQ_PIOS_FIS | PORT_IRQ_D2H_REG_FIS)
-
-/* PORT_CMD bits */
-#define PORT_CMD_ATAPI            (1 << 24) /* Device is ATAPI */
-#define PORT_CMD_LIST_ON          (1 << 15) /* cmd list DMA engine running */
-#define PORT_CMD_FIS_ON           (1 << 14) /* FIS DMA engine running */
-#define PORT_CMD_FIS_RX           (1 << 4) /* Enable FIS receive DMA engine */
-#define PORT_CMD_CLO              (1 << 3) /* Command list override */
-#define PORT_CMD_POWER_ON         (1 << 2) /* Power up device */
-#define PORT_CMD_SPIN_UP          (1 << 1) /* Spin up device */
-#define PORT_CMD_START            (1 << 0) /* Enable port DMA engine */
-
-#define PORT_CMD_ICC_MASK         (0xf << 28) /* i/f ICC state mask */
-#define PORT_CMD_ICC_ACTIVE       (0x1 << 28) /* Put i/f in active state */
-#define PORT_CMD_ICC_PARTIAL      (0x2 << 28) /* Put i/f in partial state */
-#define PORT_CMD_ICC_SLUMBER      (0x6 << 28) /* Put i/f in slumber state */
-
-#define PORT_IRQ_STAT_DHRS        (1 << 0) /* Device to Host Register FIS */
-#define PORT_IRQ_STAT_PSS         (1 << 1) /* PIO Setup FIS */
-#define PORT_IRQ_STAT_DSS         (1 << 2) /* DMA Setup FIS */
-#define PORT_IRQ_STAT_SDBS        (1 << 3) /* Set Device Bits */
-#define PORT_IRQ_STAT_UFS         (1 << 4) /* Unknown FIS */
-#define PORT_IRQ_STAT_DPS         (1 << 5) /* Descriptor Processed */
-#define PORT_IRQ_STAT_PCS         (1 << 6) /* Port Connect Change Status */
-#define PORT_IRQ_STAT_DMPS        (1 << 7) /* Device Mechanical Presence
-                                              Status */
-#define PORT_IRQ_STAT_PRCS        (1 << 22) /* File Ready Status */
-#define PORT_IRQ_STAT_IPMS        (1 << 23) /* Incorrect Port Multiplier
-                                               Status */
-#define PORT_IRQ_STAT_OFS         (1 << 24) /* Overflow Status */
-#define PORT_IRQ_STAT_INFS        (1 << 26) /* Interface Non-Fatal Error
-                                               Status */
-#define PORT_IRQ_STAT_IFS         (1 << 27) /* Interface Fatal Error */
-#define PORT_IRQ_STAT_HBDS        (1 << 28) /* Host Bus Data Error Status */
-#define PORT_IRQ_STAT_HBFS        (1 << 29) /* Host Bus Fatal Error Status */
-#define PORT_IRQ_STAT_TFES        (1 << 30) /* Task File Error Status */
-#define PORT_IRQ_STAT_CPDS        (1 << 31) /* Code Port Detect Status */
-
-#endif // ahci.h