smithtek-mako-rf 3.4.0 → 3.4.2

package/README.md

@@ -5,7 +5,7 @@ Node-RED nodes for communicating with Smithtek Mako and Solaris PLCs from a Pass
 ## Included nodes
 
 - **PassPort Connect (PPC)** is Smithtek’s proprietary communication link between PassPort, Mako and Solaris. It reads measurements and writes controls using the matching table created in V-NET2. Supports RF and RS485, plus USB for Mako.
-- **Original Mako RF** provides basic Modbus communication and remains available for existing flows. Its settings and message formats are described in the [original Mako RF guide](MAKO-RF.md). Use that guide when working with the original node.
+- **Original Mako RF** provides basic Modbus communication and remains available for existing flows. Its settings and message formats are described in the [original Mako RF guide](https://github.com/smithtekIOT/makorf/blob/main/MAKO-RF.md). Use that guide when working with the original node.
 
 ## Install
 
@@ -15,7 +15,7 @@ Before updating an existing installation, export a backup of your flows. After i
 
 ## Which guide should I use?
 
-For a new V-NET2 PassPort Connect project, follow the instructions below. A separate copy is available in [PassPort Connect setup and everyday use](PASSPORT-CONNECT.md). For an existing original Mako RF flow, use the [original Mako RF instructions](MAKO-RF.md). The two nodes use different message formats.
+For a new V-NET2 PassPort Connect project, follow the instructions below. A separate copy is available in [PassPort Connect setup and everyday use](https://github.com/smithtekIOT/makorf/blob/main/PASSPORT-CONNECT.md). For an existing original Mako RF flow, use the [original Mako RF instructions](https://github.com/smithtekIOT/makorf/blob/main/MAKO-RF.md). The two nodes use different message formats.
 
 ## PassPort Connect · setup and everyday use
 
@@ -223,4 +223,3 @@ Open Write, choose Single channel and select TestRelay. Do not leave Battery sel
 Check the relay itself or a feedback sensor, as well as the reply. For an Analog setpoint later, select that row and send a number in the original units.
 
 For a ready-wired farm project, open Farmers quick templates. Choose the picture, enter a unique Unit ID and the required sensor settings, then choose Load & export Node-RED. The project uses PassPort Connect, includes battery voltage and exports the complete Read and Write pair onto your current flow.
-

package/package.json

@@ -1,6 +1,6 @@
 {
   "name": "smithtek-mako-rf",
-  "version": "3.4.0",
+  "version": "3.4.2",
   "description": "Smithtek Mako RF and PassPort Connect nodes for Mako and Solaris readings and controls",
   "keywords": [
     "node-red",