iobroker.smartloadmanager 0.1.0 → 0.2.0

package/admin/i18n/zh-cn/translations.json

@@ -1,110 +0,0 @@
-{
-    "smartloadmanager adapter settings": "smartloadmanager的适配器设置",
-    "feedId": "饲料",
-    "consumer": "消费者",
-    "data point": "数据点",
-    "perfomance": "完美",
-    "ruleType": "RuleType",
-    "full connection": "完整的连接",
-    "Main settings": "主要设置",
-    "Feed-in data point": "进料数据点",
-    "Delay between switching operations (seconds)": "切换操作（秒）之间的延迟",
-    "Base load - threshold for switching consumers on/off": "基本负载 - 开/关的阈值",
-    "Switchable consumers": "可切换的消费者",
-    "Consumer List": "消费者列表",
-    "checkbox": "复选框",
-    "Name": "姓名",
-    "Tax data point": "税收点",
-    "Total power of the consumer (watts)": "消费者的总功率（瓦特）",
-    "Power": "力量",
-    "switch-on point": "切换点",
-    "Switching on (Watts)": "打开（瓦特）",
-    "switch-off point": "开关点",
-    "Shutdown (Watts)": "关闭（瓦特）",
-    "RuleType": "RuleType",
-    "Consumer only switches fully on or fully off, no intermediate steps (typical, for example, with wallboxes that don't like percentage control). Usable only with percentage control!!": "消费者只能完全打开或完全关闭，没有中间步骤（例如，典型的壁箱不喜欢百分比控制）。仅具有百分比控制的可用！！",
-    "feedinNegativ": "饲料",
-    "delaySecondsProzent": "百分比延迟秒",
-    "batteryDelaySeconds": "电池延迟几秒钟",
-    "Battery charging power data point (e.g. setPower)": "Bowdie Ladeleistungs-Datenpunkt（Z.B. Setpower）",
-    "Battery SOC data point (current state of charge %)": "Bowdie Soc-Datenpunkt（Aktueller ladezustand％）",
-    "Battery setpoint data point (e.g. target SOC %)": "Battie Sollwert-Datenpunkt（Z.B. Ziel-Soc％）",
-    "Battery control mode": "炮台kontrollmodus",
-    "Minimum tax value in % (from which the regulation becomes active). Only used for percentage regulation!": "百分比中的最小者steuerwert（ab wann die regelung aktiv wird）。 wird nurfürprozentregelung verwendet！",
-    "Minimum SOC (%) to stop discharge": "最小者SOC（％）zum stoppen der entladung",
-    "Priority (smallest number = highest priority)": "Priortität（Kleinste Zahl =HöchstePriortität）",
-    "FeedInDataPoint": "进料数据点",
-    "Baseload": "基本负载 - 开/关的阈值",
-    "notifyBinary": "启用通知二进制电路",
-    "notifyHeating": "启用通知加热元件",
-    "notifyPercent": "启用百分比更改的通知",
-    "notifyBattery": "启用电池更换通知",
-    "consumer-Panel": "可切换的消费者",
-    "Boolean control data point": "布尔控制数据点",
-    "tooltip_Boolean control data point": "控制数据点（输出false/true），例如：0_userdata.0.remote.poolpumpe_set_state",
-    "numericDatapoint": " - >数值控制",
-    "tooltip_numericDatapoint": "数值控制数据点（输出0 = false，1 = true）",
-    "Battery management:": "电池管理：",
-    "batterySetpoint": " - >充电能力",
-    "tooltip_batterySetpoint": "电池充电功率数据点（例如固定电源）",
-    "batterySOC": " - > SOC",
-    "tooltip_batterySOC": "电池SOC数据点（当前充电％）",
-    "batteryTargetSOC": " - >设定点",
-    "tooltip_batteryTargetSOC": "电池设定点数据点（例如目标SOC％）",
-    "batteryControlModeDatapoint": " - >控制模式",
-    "heating element": "加热元件",
-    "tooltip_batteryControlModeDatapoint": "电池控制模式",
-    "temperatureDatapoint": " - >电流温度值",
-    "tooltip_temperatureDatapoint": "加热元件的储罐中的电流温度值（电流值）",
-    "maxTemperature": " - >最高温度关闭",
-    "tooltip_maxTemperature": "加热元件的最高开关温度",
-    "minTemperature": " - >开启的最低温度",
-    "tooltip_minTemperature": "只有在此温度下，设备才能打开（防止不必要的时钟）。仅在切换过程中考虑到。",
-    "enableDatapoint": " - >硬件发布数据点",
-    "tooltip_enableDatapoint": "输入来自逆变器（启用）。如果不存在或错误，请立即关闭，无电。",
-    "heartbeatDatapoint": " - >心跳数据点",
-    "tooltip_heartbeatDatapoint": "可选的心跳数据点（true/false）。如果false→立即关闭。如果true→允许操作。",
-    "Consumer settings:": "消费者设置：",
-    "performance": "总功率（瓦特）",
-    "tooltip_performance": "消费者的总功率（瓦特）",
-    "switchOnPoint": "开关（瓦特）",
-    "tooltip_switchOnPoint": "在什么功率水平上应该打开？",
-    "switchOffPoint": "关闭（瓦特）",
-    "tooltip_switchOffPoint": "在什么功率水平上应确定关闭？",
-    "ruletype": "规则类型",
-    "binary": "打开",
-    "percent": "法规百分比",
-    "battery": "电池",
-    "heating": "加热",
-    "minPercentStart": "税率最小％",
-    "tooltip_minPercentStart": "百分比的最低税率（该法规变得有效）。仅用于法规百分比！",
-    "minSOC": "soc min％",
-    "tooltip_minSOC": "最低SOC（％）停止出院",
-    "switchOnTime": "电动时间（HH：MM）",
-    "switchOffTime": "关闭时间（HH：mm）",
-    "switchOnDelay": "打开的延迟",
-    "tooltip_switchOnDelay": "延迟打开几秒钟",
-    "switchOffDelay": "延迟关闭",
-    "tooltip_switchOffDelay": "延迟在几秒钟内关闭",
-    "alwaysOffAtTime": "仅在关闭时间关闭",
-    "priority": "优先事项",
-    "tooltip_priority": "优先级（最小数字=最高优先级）",
-    "Notifications": "通知",
-    "telegramInstance": "电报实例",
-    "telegramRecipients": "电报收件人（分开逗号）",
-    "gotifyInstance": "Gotify实例",
-    "emailInstance": "电子邮件实例",
-    "emailRecipients": "电子邮件收件人（分开逗号）",
-    "whatsappInstance": "WhatsApp-CMD实例",
-    "whatsappRecipients": "WhatsApp收件人（逗号分隔）",
-    "signalInstance": "信号CMD实例",
-    "signalRecipients": "信号接收者（逗号分隔）",
-    "pushoverInstance": "Pushover实例",
-    "pushoverRecipients": "Pushover接收者（分开逗号）",
-    "enableNotificationManager": "使用通知管理器",
-    "Active": "积极的",
-    "name": "姓名",
-    "controlMode": "控制模式",
-    "onTimerRemaining": "定时器剩下",
-    "offTimerRemaining": "计时器剩下"
-}

package/lib/adapter-config.d.ts

@@ -1,20 +0,0 @@
-// This file extends the AdapterConfig type from "@types/iobroker"
-// using the actual properties present in io-package.json
-// in order to provide typings for adapter.config properties
-
-import { native } from '../io-package.json';
-
-type _AdapterConfig = typeof native;
-
-// Augment the globally declared type ioBroker.AdapterConfig
-declare global {
-    namespace ioBroker {
-        interface AdapterConfig extends _AdapterConfig {
-            // Do not enter anything here!
-            consumer;
-        }
-    }
-}
-
-// this is required so the above AdapterConfig is found by TypeScript / type checking
-export {};