@procore/bim-webviewer-sdk 6.5.0 → 6.6.0-BIM-2376.0

This diff represents the content of publicly available package versions that have been released to one of the supported registries. The information contained in this diff is provided for informational purposes only and reflects changes between package versions as they appear in their respective public registries.
package/CHANGELOG.md CHANGED
@@ -5,7 +5,25 @@ All notable changes to this project will be documented in this file.
5
5
  The format is based on [Keep a Changelog](https://keepachangelog.com/en/1.0.0/),
6
6
  and this project adheres to [Semantic Versioning](https://semver.org/spec/v2.0.0.html)
7
7
 
8
- ## [6.5.0] - 2022-1-9
8
+ ## [6.6.0] - 2022-01-23
9
+
10
+ ### Changed
11
+
12
+ - Coachmarks have new design and will now be located in the lower left hand corner of the canvas.
13
+ - Make camera movement with Orbit Tool independent of framerate. A mouse movement halfway across your screen should mean the same amount of rotation on both the smallest and largest models (i.e. regardless of how laggy/low framerate).
14
+ - A consequence of this is that orbiting should feel "faster" on larger models.
15
+ - A caveat to this is that the improvement is only currently implemented for orbiting in the Orbit Tool. Orbiting in Fly, Default, or after taking a measurement with Measure are still using the old implementation for now.
16
+
17
+ ### Fixed
18
+
19
+ - Fixed various issues where we could not find intersection points for objects that were very small on the screen (i.e. actually small or just very far away).
20
+ - Selection of small/far away objects would sometimes fail in Default, Fly, Orbit, and Measure modes. This should no longer happen.
21
+ - Orbiting in Orbit mode would sometimes fail to find an orbit point on small/far away objects and would subsequently not move the camera. This should no longer happen.
22
+ - The context menu would sometimes fail to appear when a small/far away object was right-clicked. This should no longer happen.
23
+ - Scrolling to zoom uses the distance from the camera to the object the mouse is over to adjust the zoom speed but would sometimes fail to find an intersect point and would zoom at the default (slow) speed until you got close enough for it to find an intersection and would then suddenly speed up. It should now always find an intersection point if your mouse is over an object.
24
+ - Panning could sometimes fail to find a point to lock the pan to and would default to the model center. It should now always find a point.
25
+
26
+ ## [6.5.0] - 2022-01-09
9
27
 
10
28
  ### Added
11
29